HUMPHREE INTERCEPTORS H-SERIES KIT
H-Series KIT
H-Series are available from 350 – 1500 mm in width.
H-Series characterizes a customizable interceptor.
We can custom shape it for the hull and make it fit under your water jet, a perfect fit at the shine or make it follow the radius of the propeller tunnels, no matter how the hull has been designed there is always a solution.
Available sizes: 350 – 1500mm
Stroke length: 50mm
Mounting plates: 20mm composite or 25mm aluminium
Transom thickness: Short shaft kit (standard),<80mm transom thickness. Long shaft kit (option),<140mm transom thickness
Bureau Veritas approved through-hull design
Humphree trim and stabilisation system
Auto Trim, Auto Listings, Coordinated the turn and Active Ride Control. The system increased speed, reduced turning radius and fuel consumption, balanced turns more and reduced the acceleration time significantly.
Auto Trim Control
Accelerating and operating at different speeds often means the boat will run with various trim angles. In many situations this results in a poor trim angle, high wave resistance, bad visibility and reduced comfort. Instead of manual adjustment of the Humphree Interceptors, the Automatic Trim Control will give full automatic control of the longitudinal trim by pushing a button.
Auto List Control
Uneven loading, cross winds and varying conditions will normally cause the boat to list. When running in a straight course, Automatic List Control will correct the boat list to a preset target list angle, usually zero degrees. This can be changed by the operator to intentionally list the boat. When the boat enters a turn the system will allow the boat to heel naturally during the turn and once the boat has left the turn the system will continue to correct the boat to the preset target list angle
Coordinated Turn
For numerous applications the heel angle when turning can be significantly improved to obtain higher speed and increased comfort.The Coordinated Turn Control automatically adjusts the heeling angle of the boat during turns to reduce the side forces for people on board.The system continuously monitors the rudder position during the turn and the Interceptor blade movement is thus automatically coordinated with the rudder movement. With a controlled heel angle, higher turning speeds and better comfort can be achieved.The boat’s turning ability can also be significantly improved as a result of the steering force created by the Interceptor which increases the yaw motion of the boat.
Active Ride Control
When operating in open waters wave induced roll and pitch motions onboard vessels usually causes discomfort to all onboard. With a humphree ACTIVE ride control system these motions can be significantly reduced. The ACTIVE system also includes automatic trim and list control moreover compensating for cross winds or uneven loadings – all in one system.
How does it work?
The basic principle of the interceptor trim tab is to create preassure underneath the hull, at the stern of the boat. The pressure is created when the blade is deployed into the waterflow underneath the hull. This lift will change the running trim of the vessel resulting in a lower wave resistance. That is way the interceptor blade need to reach as deep as possible below the boat to create as much lifting force as possible.
Humphree has the fastest and longest interceptor blades on the market, which gives a very good result instantly. With interceptor blades of at least 50 mm length moving with accuracy and high speed the movement of the boat will be affected tremendously.
Humphree_Interceptors_range_brochure.pdf
